Brake! LED taillights are brighter and MUCH more visible than traditional incandescent taillights.
For increased safety, the brake light also STROBES for several seconds when the brake is applied, and then stays on like a regular brake light. It practically screams “Hey! I’m stopping! Back off!” Install a Brake! LED taillight and watch people stop ten feet farther behind you at the next traffic light. And you can experiment to see what works best for you; the Brake! LED taillight offers several modes easily changed just by flipping a switch. Choose from no strobe (normal), a short or long duration strobe followed by constant light, or continous strobe whenever the brake is applied.
LEDs also produce a saturated, wavelength-specific light—in this case deep, intense red—without any heat or wasted light energy, leaving more of your bike alternator’s output for the headlights and accessories.
Installation is easy! Brake! LED conversion kits fit your existing taillight housing without any cutting or permanent modifications to your bike. Not only that, but you’ll never have to change a light bulb again. But to re-install the original bulb is just as easy. The LEDs used are designed specifically for the automotive industry, and are rated to last over 100,000 hours. That’s like leaving your bike running non-stop for over 11 years! LEDs are more rugged than traditional filament bulbs, ideal for rough usage on dual-sport bikes.
- Extremely bright
- Set for steady, or 3 flash modes
- Works with all BMW systems including EVO and ABS
- Easy installation
| 
